Septic Systems
Households that are not
served by public sewers usually depend
on septic tank systems to treat and
dispose of wastewater. A well-designed,
installed, and maintained septic system
can provide years of reliable low-cost
service. When these systems fail to
operate effectively, property damage,
groundwater, surface pollution, and
disease outbreaks can occur. Therefore,
it makes good sense to understand and
care for your septic tank system.

There are many different
types of septic tanks systems to fit
a wide range of soil and site conditions.
The following information will help
you understand a conventional gravity-flow
septic system and keep it operating
safely at the lowest possible cost.
A conventional septic tank system has
three working parts:
- The septic tank.
- The drainfield with its replacement
area.
- The surrounding soil.
The typical septic tank
is a large buried rectangular or cylindrical
container made of concrete, fiberglass,
or polyethylene. Wastewater from your
toilet, bath, kitchen, laundry, etc.,
flows into the tank. Heavy solids settle
to the bottom where bacterial action
partially decomposes them to digested
sludge and gases.
Most of the lighter solids,
such as fats and grease, rise to the
top and form a scum layer. Septic tanks
may have one or two compartments. Tees
or baffles are provided in the tank's
inlet and outlet pipes. The inlet tee
slows the incoming wastes and reduces
disturbance of the settled sludge. The
outlet tee keeps the solids or scum
in the tank. All tanks should have accessible
covers for checking the condition of
the baffles and for pumping both compartments.
If risers extend from the tank to or
above the ground surface, they should
be secure to prevent accidental entry
into the tank.
Solids that are not decomposed
remain in the septic tank. If not removed
by periodic pumping, solids will accumulate
until they eventually overflow into
the drainfield. Most septic tanks need
to be pumped every 3 to 5 years, depending
on the tank size, the amount used and
the type of solids entering the tank.
The wastewater leaving the septic tank
is a liquid called effluent. It has
been partially treated but still contains
disease-causing bacteria and other pollutants.
The Drainfield
The drainfield receives
septic tank effluent. It has a network
of perforated pipes laid in gravel-filled
trenches (2-3 feet wide), or beds (over
3 feet wide) in the soil. Wastewater
trickles out of the pipes, through the
gravel layer, and into the soil. The
size and type of drainfield is required
to have a designated replacement area.
It must be maintained should the existing
system need an addition or repair.
Typical Conventional
Drainfield System
The soil below the drainfield
provides the final treatment and disposal
of the septic tank effluent. After the
effluent has passed into the soil, most
of it percolates downward and outward,
eventually entering the groundwater.
A small percentage is taken up by plants
through their roots, or evaporates from
the soil. The soil filters effluent
as it passes through the pore spaces.
Chemical and biological processes treat
the effluent before it reaches groundwater,
or a restrictive layer, such as hardpan,
bedrock, or clay soils. These processes
work best where the soil is somewhat
dry, permeable, and contains plenty
of oxygen for several feet below the
drainfield.
Warning signs of a failure:
- Odors, surfacing sewage, wet spots
or lush vegetation in the drainfield
area.
- Plumbing or septic backups.
- Slow-draining fixture.
- Gurgling sounds in the plumbing system.
If you notice any of these signs or
if you suspect your septic tank system
may be having problems, contact Mr.
Drain Cleaner for assistance.
Caring for your
System:
Practice water conservation.
The more wastewater you produce, the
more the soil must be treated and disposed
of. By reducing and balancing your water
use, you can extend the life of the
drainfield, decrease the possibility
of system failure, and avoid costly
repairs.
Keep accurate records.
Know where your septic tank system is
and keep a diagram of its location.
Records of its size and location may
be available at your local health agency.
It is also wise to keep a record of
maintenance on the system. These records
will be helpful if problems occur, and
will be valuable to the next owner of
your home.
Inspect your system
once each year. Check the sludge and
scum levels inside your septic tank
to assure that the layers of solids
are not within the early warning levels.
Also check the tank to see if the baffles
and tees are in good condition. Periodically
inspect the drainfield and downslope
areas for odors, wet spots, or surfacing
sewage. If your drainfield has inspection
pipes, check them to see if there is
a liquid level continually over 6 inches.
This may be an early indication of a
problem.
Pump out your septic
tank when needed. Don't wait until you
have a problem. Routine pumping can
prevent failures, such as clogging of
the drainfield and sewage back-up into
the home. Using a garbage disposal will
increase the amount of solids entering
the septic tank, requiring more frequent
pumping.
Never flush harmful
materials into the septic tank. Grease,
cooking fats, newspapers, paper towels,
rags, coffee grounds, sanitary napkins,
and cigarettes cannot easily decompose
in the tank. Chemicals such as solvents,
oils, paint, and pesticides are harmful
to the system's proper operation and
may pollute the groundwater.
Keep all runoff away
from your system. Water from surfaces
such as roofs, driveways, or patios
should be diverted sway from the septic
tank and drainfield area.
Protect your system
from damage. Keep traffic, such as vehicles,
heavy equipment, or livestock off your
drainfield or replacement area. The
pressure can compact the soil or damage
pipes. Before you plant a garden, construct
a building, or install a pool, check
on the location of your system and replacement
area.
Landscape your system
properly. Don't place impermeable materials
over your drainfield or replacement
area. Materials, such as concrete or
plastic, reduce evaporation and the
supply of oxygen to the soil for proper
effluent treatment. They can also hinder
access to the system for pumping, inspection,
or repair. Grass is the best cover for
your system.
Never enter any
septic tank. Poisonous gases or the
lack of oxygen can be fatal. Any work
on the tank must be done from the outside